This software updates the LinkStation firmware to version 1.81. If your firmware is already version 1.81 or later, you do not need this update.

Note: If your LinkStation is in EM mode, this firmware update might recover it.

How to Check Your Firmware Version:

Select your LinkStation from the NAS Navigator2 window. The firmware version is displayed in the bottom right corner ... the name is in the form LS-***-EM***, the LinkStation is in EM (emergency) mode.

Version History

How to Update the Firmware

1. Connect the LinkStation properly and configure the LinkStation and a computer to run the updater on the same network subnet. The subnet masks ... the IP address and subnet mask of the LinkStation are

" 192.168.1.150 , 255.255.255.0 "

then the updater will _not_ work properly.

In this case, reconfigure the LinkStation's IP address and subnet mask to

" 192.168.0.150 ... will be on the same subnet and the updater will work properly.

2. Close all applications. Also, ... the downloaded file and run "LSUpdater.exe". When a LinkStation is detected, an update window will open.

4. Select the LinkStation to update if multiple LinkStation are connected.

5. Click "Update" and enter the LinkStation's admin password.

6. Click "OK".

7. Transferring and updating the firmware will start. Wait until it finishes. The info ... a message will be displayed.

About NAS Firmware:

Upgrading the Network-Attached Storage (NAS) firmware can improve the system’s overall performance, stability, and ... well as network storage types, installing a new firmware might not be always as easy as it ... guide, click the download button to apply this firmware version to your NAS. Remember to check back ...