Added and Modified Features:

- [Drives]: Modified the drive check process that ... >/

Caution:

- Please consult your local technical support representative if you experience any problems caused by ... after a firmware update. To mount them, unplug and then reconnect them.

How to Use the Updater:

1. Connect the LinkStation properly and configure the LinkStation and a computer to run the updater on the ... subnet. The subnet masks should be the same and the first three numbers of the IP addresses ... different.
For example, if the IP address and subnet mask of the computer are
" 192.168.0.10 , 255.255.255.0 "
and the IP address and subnet mask of the LinkStation are
... In this case, reconfigure the LinkStation's IP address and subnet mask to
" 192.168.0.150 , ... Then they will be on the same subnet and the updater will work properly.
2. Close ... software.
3. Extract the downloaded file and run ""LSUpdater.exe". When a LinkStation is detected, an ... multiple LinkStation are connected.
5. Click "Update" and enter the LinkStation's admin password.
6. Click "OK".
7. Transferring and updating the firmware will start. Wait until it ... firmware can improve the system's overall performance, stability, and security by adding various fixes for related issues, enhancing existing features (or adding support for new ones), or updating different applications.
... be always as easy as it appears – and not too safe either. Failing to perform a ... applying this release, carefully read the installation guide and initiate the process only when you have understood and completely familiarized yourself with all the steps.
... point before installing a device driver. This will help if you installed an incorrect or mismatched driver. ... your hardware device is too old or not supported any longer.